Re: RSG Mounting Problem

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Allan Scott" <ascott16-at-cogeco.ca> 


----- Original Message -----
Just a suggestion dont know if it would work for your disk but how about a
pully that fits the shaft and modify it or your disk to fit one another

From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, January 11, 2004 3:23 PM
Subject: RSG Mounting Problem


 > Original poster: "Ian McLean" <ianmm-at-optusnet-dot-com.au>
 >
 > Hi everyone,
 >
 > Anyone know where I can get a hub for a half inch shaft (cheap) that I can
 > use for my tungsten SRSG?  Only thing holding up it's completion.  Prefer
a
 > four hole connector plate on the end, and hollow all the way through, with
 > grub screws.  Having lot's of trouble trying to find something I can use
to
 > attach to my 12" diameter, 1/4 inch thick HDPE platter.
 >
 > The motor spindle is 1/2" dia shaft with a flat down one side, ideal for a
 > 1/2" holed assembly with one or two grub screws.  I would prefer the hole
to
 > go all the way through the hub for best alignment capability.  Any ideas
 > where I can get something like this anyone ?
 >
 > Oh how I wish I had access to a lathe ...
 >
 > PS: I am in Sydney, Australia.
 >
 > Thanks and regards
 > Ian.
 >
 >