RE: Three Phase Primaries Revised.

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Ian McLean" <ianmm-at-optusnet-dot-com.au> 

Am looking forward to hearing about your results ;)

Rgs
Ian

 > -----Original Message-----
 > From: Tesla list [mailto:tesla-at-pupman-dot-com]
 > Sent: Sunday, 4 January 2004 2:13 pm
 > To: tesla-at-pupman-dot-com
 > Subject: Three Phase Primaries Revised.
 >
 >
 > Original poster: Harvey Norris <harvich-at-yahoo-dot-com>
 >
 > I once considered it rediculous that modifications to
 > a possible alternator tesla coil arrangement using
 > three phase should only use one secondary coil.
 > Instead I thought this should automatically presume
 > three primaries and three secondaries. That of course
 > would be a major accomplishment. However a formidable
 > barrier of power input seems readily problematic for
 > alternator schemes, so to superceed those requirements
 > we might wish to design schemes where the most
 > possibly efficient rf bursts occur on primaries, to
 > make up for the lack of input power. In this regard we
 > give each phase a spiraled primary, with the middle
 > phase or wind to be wound oppositely. To accomplish
 > this we test the three phase primary system both
 > inductively, and also with the primary system set to
 > source frequency resonance 480 hz of the alternator,
 > which is determined by the inductive reactance tests
 > made on the first testing showing the influence of
 > mutual inductance. These tests then assign "new" Lp
 > values for each winding according to the evidenced
 > mutual induction, and assign Cp values to each winding
 > in accordance with the desired frequency. I am trying
 > this alternator/ three phase primary concept with
 > Radio Shack Megacable speaker wire spirals. This may
 > end up being a fairly small coil try.
 > HDN
 >
 >