Secondary form coating.

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Luke" <Bluu-at-cox-dot-net> 

Has anyone ever used Plasti Dip for a secondary coil form coating (under 
the wire)?
Plasti Dip is that liquid rubber in a can you coat tool handles etc. with.

Does it insulate well enough?  There are areas I would like to use it in.
My form is already coated in Glytol.  But in the future thought Plasti Dip 
might work.  The rubbery consistency might allow the wire to sink into it a 
bit as it is wound.  This might help reduce the amount of air trapped below 
the wire and between windings.

Thoughts??????

Main question though, does it insulate well enough?

Luke Galyan
Bluu-at-cox-dot-net