Re: PVC Toroid Source?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Yurtle Turtle <yurtle_t-at-yahoo-dot-com> 

Depending on the diameter, PVC bends quite well with a
heat gun. The trick is to get it just soft enough to
bend and not to kink it. Probably not practical over
4".

Adam

--- Tesla list <tesla-at-pupman-dot-com> wrote:
 > Original poster: "Daniel Kline"
 > <daniel_kline-at-med.unc.edu>
 >
 > All,
 > I was thinking about bending PVC tubing into a
 > toroidal shape
 > for covering with aluminum tape and ran across this
 > site. I'm
 > not sure if the elbows would work, but I'm thinking
 > the sweeps
 > might? They go up to 6" in a variety of radii.
 > Dan K.
 >
 > http://www.pvc-conduitfittings-dot-com/
 >
 >