Re: Help needed with voltage divider

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Dr. Resonance" <resonance-at-jvlnet-dot-com> 


Possible electrolysis (breakdown) of the water into hydrogen and oxygen if
the power level is high enough.  If the tube is sealed the gases have no
where to go.

Dr. Resonance



 > Original poster: "Denicolai, Marco" <Marco.Denicolai-at-tellabs-dot-com>
 >
 > Hello all,
 >
 > I am also proceeding with my water voltage divider roughly described at
 >
 > http://www.iki.fi/dncmrc/work/hv_divider.htm
 >
 > My sealed distilled water column gives a 1:60 division ratio and a
 > second (compensated) stage at the bottom of it a 1:10 ratio, for a total
 > of about 1:600 ratio. The first stage resistance is about 1.2 Megaohms.
 > On the column top I have two copper pipes (6 mm o.d.) I used to pump
 > water in and air out. I used an old refrigerator pump to extract all the
 > air I could from the water. Then I sealed (soldered) the pipe tops. The
 > pipe tops and the bottom networks remain both enclosed inside two
 > rounded aluminium caps. Just a shielded cable going out of the ground
 > (bottom) terminal.
 >
 > After two weeks from the sealing air bubbles started again forming
 > inside the (plexi) tube. I am pretty sure I have no leaks. There are
 > also no sediments inside. The water is still clear. So, what's going on?
 > How pros do to get read of the air dissolved in the water?
 >
 > Anybody who can help me with this?
 >
 > Regards
 >
 > --
 >
 >
 >