[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: protecting a 4 pack mot stack

To: tesla-at-pupman-dot-com
Subject: RE: protecting a 4 pack mot stack
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 31 Mar 2004 17:46:04 -0700
Resent-Date: Wed, 31 Mar 2004 17:50:48 -0700
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <MRdu0D.A.eIC.Pd2aAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Peter Reid" <peter-at-reidconsulting-dot-com.au> 

If you have a proper safety gap between each leg of the HV output and
ground and its set well you shouldn't have any problems.

Peter.

-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com]
Sent: Thursday, 1 April 2004 12:55 AM
To: tesla-at-pupman-dot-com
Subject: protecting a 4 pack mot stack

Original poster: eric <hydrogen18-at-hydrogen18-dot-com>

do i need to design and implement a terry filter and safety gap like the

one used to protect NST's or will my 4 pack MOT be fine in tesla coil
service without any problems?

Prev by Date: Measurement with Voltage Divider (was: strange vttc)
Next by Date: Re: RE: strange vttc
Prev by thread: protecting a 4 pack mot stack
Next by thread: Re: protecting a 4 pack mot stack
Index(es):
- Date
- Thread