Re: PlasmaSonic II SSTC Board SALE $25.00 EACH or $45.00 for TWO

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net> 

But that requires building a whole separate feedback system which is a lot
of work,  It would be easier just to use the onboard Tl494 oscillator.  Not
the mention that the MOSFETs your design uses cost about 80$ each!

Regards - Jim Mitchell
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Friday, March 26, 2004 5:43 PM
Subject: RE: PlasmaSonic II SSTC Board SALE $25.00 EACH or $45.00 for TWO


 > Original poster: "Mccauley, Daniel H" <daniel.h.mccauley-at-lmco-dot-com>
 >
 >  >Is it possible to make this thing feedback operational?If so, ill take
 > one.
 >
 > Matt
 >
 > Absolutely.  Some will argue this board is inferior because it doesn't
 > have that option built in, but in fact
 > the most important thing on the PlasmaSonic is the full-bridge and
 > driver section.
 >
 > Also, this driver can fully utilize the better operation of the
 > UCC37322/21 MOSFET drivers chip which have
 > lower output impedance and also supports parallel operation of these
 > MOSFET drivers as well.
 >
 > Any type of antenna base feedback or other oscillator can easily be put
 > on the board with minimal problems.
 > A simple radio shack prototype board (about 1" x 1") can be bought, the
 > feedback board installed on this, and
 > this attached right to the top of the Plasmasonic board.  VERY EASY!
 >
 > Dan
 >
 >
 >
 >
 >
 >
 >
 >