Re: phasing GDTs with MOSFETS

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Fucian-at-aol-dot-com 

Is there a way to do this with just one channel?I have a 2 channel scope 
but just one probe...BTW-scope wroks good!

Also, did i measure my GDT right?I did this:

I connected the primary to the driver and then took the probe ground and 
clipped it to circuit ground, not the output, then i probed one of the 
secondary output pins(commercial GDT) I got a decent square wave with a WEE 
bit of noise on the wave...

Matt