[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: SSTC PCB Boards - Anyone interested ? ? ?



Original poster: "Jonathan Peakall by way of Terry Fritz <teslalist-at-qwest-dot-net>" <jpeakall-at-madlabs.info>

Dan,

Count me in.

Jonathan

www.madlabs.info


----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, May 29, 2003 4:28 PM
Subject: Re: SSTC PCB Boards - Anyone interested ? ? ?


 > Original poster: "James by way of Terry Fritz <teslalist-at-qwest-dot-net>"
<mustang3-at-cox-dot-net>
 >
 > Hi Dan,
 >      I'll take one. My toob coils both work well. Haven't tried the stacco
 > yet. I played with it using my oscope; the board worked well. I suppose
that
 > I should do an ss coil.
 >
 > Later,
 >
 > James
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Thursday, May 29, 2003 8:46 AM
 > Subject: SSTC PCB Boards - Anyone interested ? ? ?
 >
 >
 >  > Original poster: "by way of Terry Fritz <teslalist-at-qwest-dot-net>"
 > <dhmccauley-at-spacecatlighting-dot-com>
 >  >
 >  > I'm currently working on a simple (2) FET h-bridge type SSTC design
with
 > the
 >  > following specifications which I am planning on using for some upcoming
 >  > dual/quad type coil arrays.  The
 >  > boards will have the following specifications:
 >  >
 >  > 1.  Dual FET h-bridge design (push-pull)
 >  > 2.  TL494 Controller utilizing push-pull topology
 >  > 3.  Full audio modulation capabilities
 >  > 4.  On board shielded pre-amplifier to accept RCA type (high impedance)
 >  > audio inputs
 >  >
 >  > I'm going to have boards made by the end of June, so if anyone is
 > interested
 >  > in getting in on the purchase (blank boards), please let me know.  It
will
 >  > be similar to how the Stacatto Board
 >  > orders worked.  If I get 10 orders, boards will be approximately $30.00
 >  > each.
 >  >
 >  > The Captain
 >  >
 >  >
 >
 >
 >
 >
 >