[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: SSTC PCB Boards - Anyone interested ? ? ?



Original poster: "James by way of Terry Fritz <teslalist-at-qwest-dot-net>" <mustang3-at-cox-dot-net>

Hi Dan,
     I'll take one. My toob coils both work well. Haven't tried the stacco
yet. I played with it using my oscope; the board worked well. I suppose that
I should do an ss coil.

Later,

James
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, May 29, 2003 8:46 AM
Subject: SSTC PCB Boards - Anyone interested ? ? ?


 > Original poster: "by way of Terry Fritz <teslalist-at-qwest-dot-net>"
<dhmccauley-at-spacecatlighting-dot-com>
 >
 > I'm currently working on a simple (2) FET h-bridge type SSTC design with
the
 > following specifications which I am planning on using for some upcoming
 > dual/quad type coil arrays.  The
 > boards will have the following specifications:
 >
 > 1.  Dual FET h-bridge design (push-pull)
 > 2.  TL494 Controller utilizing push-pull topology
 > 3.  Full audio modulation capabilities
 > 4.  On board shielded pre-amplifier to accept RCA type (high impedance)
 > audio inputs
 >
 > I'm going to have boards made by the end of June, so if anyone is
interested
 > in getting in on the purchase (blank boards), please let me know.  It will
 > be similar to how the Stacatto Board
 > orders worked.  If I get 10 orders, boards will be approximately $30.00
 > each.
 >
 > The Captain
 >
 >