Re: Source for Aluminum Disks ? ? ? ?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Lux by way of Terry Fritz <teslalist-at-qwest-dot-net>" <jimlux-at-earthlink-dot-net>

Use a router to machine the edges round.  Aluminum is pretty soft (unless 
you went out and got some super hard alloy)

At 07:05 AM 5/5/2003 -0600, you wrote:
>Original poster: "Mccauley, Daniel H by way of Terry Fritz 
><teslalist-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>
>
>Anyone know of a source that sells aluminum disks which already machined
>with radius outside edges??  I'm looking
>for a size of about 5-6" diameter, 0.5" thick.
>
>I did purchase stock disks (5" x 0.5" aluminum) from McMaster-Carr and my
>friend was supposed to machine it for me (radius the outside edge etc...),
>but he's been slacking off for the past 4-5 weeks and i need to go another
>route than having to depend on him.
>
>I'll be using this for my dual 833A VTTC topload.
>
>Thanks
>
>The Captain