Re: New SSTC Design Topology

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Chris Swinson by way of Terry Fritz <teslalist-at-qwest-dot-net>" <exxos-at-cps-games.co.uk>

Hi captain,



----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Wednesday, February 26, 2003 6:20 PM
Subject: New SSTC Design Topology


 > Original poster: "Mccauley, Daniel H by way of Terry Fritz
<teslalist-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>
 >
 >
 > I'm currently working on a new high power SSTC Design Topology which will
 > basically use a 2100V input (either DC, or AC -
 > full or half rectified) and utilize a high frequency / high voltage
 > switching circuit which will run at 100-200 kHz
 > approximately.  Basically its going to utilize (6) 1000V FETs (IXFN24N100)
 > type in a cascoded gate topology and initial
 > simulations look promising.  I'll keep you all posted.  Its actually a
 > simple circuit and much easier to implement than
 > the full-bridge topology which is limited to lower operating voltages.
I've
 > already built some high voltage switched
 > loads using similar topologies (albeit higher voltages and less current),
 > but results should be similar.
 >
 > The Captain
 >

It will be very interesting to see some new designs with SSTC work! keep us
posted and good luck :)
Chris