Re: Design Review Volunteers Needed - VTTC Staccato Controller Circuit

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Steven Ward by way of Terry Fritz <teslalist-at-qwest-dot-net>" <srward16-at-hotmail-dot-com>

Hi,

Dan is using the design that John Freau, and I have used successfully on 
our tube coils.  I believe when i last looked over Dans schematic, the only 
difference were some additional bypass caps, and some other things to 
reduce RF.  And most likely, if not needed, would not effect the operation 
of the board.  But i guess basically, John and I prototyped the board for 
him.  So as long as he uses the same schematic as is on my site, then it 
should be just fine.

Steve Ward.






>From: "Tesla list" <tesla-at-pupman-dot-com>
>To: tesla-at-pupman-dot-com
>Subject: Re: Design Review Volunteers Needed - VTTC Staccato Controller
>Circuit
>Date: Tue, 04 Mar 2003 12:48:44 -0700
>
>Original poster: "Mike Veldman by way of Terry Fritz 
><teslalist-at-qwest-dot-net>" <vmike-at-email.ceat.okstate.edu>
>
>Your circuit looks electrically functional, I did'nt see any glaring
>mistakes.  Now my question is, have you prototyped the circuit?  Pardon my
>being an old engineer, but I fail to understand going from circuit diagram
>to board without a working model in my hand.  Simulation software is not a
>sure thing.
>mike
>