[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Has this been tried?

To: tesla-at-pupman-dot-com
Subject: Has this been tried?
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Thu, 03 Jul 2003 20:17:24 -0600
Resent-Date: Thu, 3 Jul 2003 20:33:45 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <v1rUmC.A.d2E.GeOB_-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Christopher \"CajunCoiler\" Mayeux by way of Terry Fritz <teslalist-at-qwest-dot-net>" <cajuncoiler-at-cox-dot-net>

While at the local Wal-Mart, I noticed a variety
of white plastic cutting boards for cheap, and I
pondered if anyone has tested these for thier
insulative properties against high voltage. It's
a hard plastic, and would probably make a good
perf board for an MMC or a "Terry Filter" if it
were suitable.  Has anyone tried these yet?

Prev by Date: Re: Problems with SRSG on TC
Next by Date: Re: Early versions of Tesla's coil
Prev by thread: Re: Has this been tried?
Next by thread: Re: Has this been tried?
Index(es):
- Date
- Thread