[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Splicing Primary Copper Tubing

To: tesla-at-pupman-dot-com
Subject: Splicing Primary Copper Tubing
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 05 Feb 2003 07:59:20 -0700
Resent-Date: Wed, 5 Feb 2003 08:07:43 -0700
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <z-T8LD.A.jFF.5iSQ--at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Mccauley, Daniel H by way of Terry Fritz <teslalist-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>


My primary tubing is a bit short (only comes in 100ft lengths), and I need
to splice on a few more turns with additiona.
tubing.  Not being a plumber, I have no clue how to splice copper tubing?

Anyone have a brief description how this is done?  I guess its done with a
blowtorch, plumber's solder, and some flux.

Any help appreciated.

Thanks

Dan

Prev by Date: Re: Colorado Spring Notes
Next by Date: Re: high voltage measurement w/ divider
Prev by thread: Re: Aussie question: Toroid as a shorted turn
Next by thread: RE: Splicing Primary Copper Tubing
Index(es):
- Date
- Thread