[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: parallel line filters?



Original poster: "cd by way of Terry Fritz <twftesla-at-qwest-dot-net>" <vbprg1-at-hotmail-dot-com>

How do you determine the  amout of amps drawn during operation?
I have been using 12000v 30ma neons that are rated at 3.6 amps each
I realize they are inefficient transformers but
putting 2 in parallel for 12000v 60ma I have had no problems
pulling through a 12 amp variac...

I have recently decided to up my PS to 12000v 90ma
but am unsure weather I will have to use
a PFC motor run cap setup to pull through my 12 amp variac

Chris




----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, October 06, 2002 7:08 PM
Subject: Re: parallel line filters?


> Original poster: "davep by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<davep-at-quik-dot-com>
>
> > Original poster: "Shaun Epp by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <scepp-at-mts-dot-net>
>
> > I have a few questions regarding line filters.
>
> > My tesla coil, using a 12Kv, 60mA NST, draws about 13
>
> > amps average when running, but the line filters I have
>
> > are only good for 6, 9, and 10 amps at 250 Volts.
>
> In general the two ratings, voltage, and current, are
> independent, in this cae.
>
> > I am running my coil on 120 volts.  Could I parallel two
>
> > 10 amp line filters ( identical units)
>
> I'd expect it to work.  IIR, this was discussed
> within the last 6 months, might be something
> useful in the archives...
>
> > together for a higher current rating, would this be necessary
>
> > or would one filter do it,
>
> Might.  Iffy.  Failure modes can destroy the filter.
>
>
> > would the current split evenly between the two filter?
>
> Should, tho the split will not be exact, exact.
>
> > I'm not sure if running them at 120 volts would change the
>
> > current rating capacity on the filters or not.
>
> Good thought.  It shouldn't.  Voltage is set by
> voltage ratings of caps, etc.  Current by
> internal wiring, and wire used in inductors.
> The two are independent.
>
> > Also I run my tesla coil for short runs, could this current
>
> > rating be for continuous use?
>
> Almost certainly.
>
> > or would a higher current than rated saturate the filter and
>
> > make it ineffective?
> Certainly possible.  If the other filter is available,
>
> I'd use both...
>
>
> > Looking for an expert,
> I'm not quite an Expert, but know a bit...
>
>
> best
> dwp
>
> ...the net of a million lies...
> Vernor Vinge
> There are Many Web Sites which Say Many Things.
> -me
>