Re: mdpe tubing for secondary form

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Mike by way of Terry Fritz <twftesla-at-qwest-dot-net>" <megavolts61-at-yahoo-dot-com>

Hello All,

I have found a source of MDPE tubing (thanks to Mark
Finnis).  The
tubing they have is 200mm (8") but the walls are 8-9mm
thick.

I have heard that the thickness of the tubing will
affect the
performance of the coil?  

Is this thickness going to be a problem?

Justin,
   The thickness should not affect performance
noticibly due to the low dissipation of PE.  I think
the hardest part will be getting the wire to 'stick'
to the form.
Mike