[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Original poster: "jimmy hynes by way of Terry Fritz <twftesla-at-qwest-dot-net>" <chunkyboy86-at-yahoo-dot-com>
no, it's a failure it didn't work but i dont know
where to start checking with the dmm because there are
11 pins and 3 wires going in. (including the high
voltage one with the suction cup) 9 of the pins are in
a U shape and the other two are just off the side.
does anyone have any idea where i should start?
--- Tesla list <tesla-at-pupman-dot-com> wrote:
> Original poster: "Ed Phillips by way of Terry Fritz
> <twftesla-at-qwest-dot-net>" <evp-at-pacbell-dot-net>
> Tesla list wrote:
> > Original poster: "rheidlebaugh by way of Terry
> <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>
> > Jimmy: not all potting can be removed with
> solvent. Those that can are
> > usualy soften with Methylene chloride or methyl
> ethyl ketone.
> > Robert H
> I suspect that just about ALL agents which can
> soften or remove the
> potting will, at the same time, remove the
> insulation from the wire
> inside. That might be a hollow
Do You Yahoo!?
Yahoo! - Official partner of 2002 FIFA World Cup