[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Phenolic Supplier question.
Original poster: "Terry Fritz" <twftesla-at-qwest-dot-net>
My favorite supplier:
has 1/2 inch thick sheets of 12 x 12 inch G-10 epoxy fiberglass for $50.71
(part number 63407639). Same size in LE is about $37 (63413264)... So the
prices you give are about 3X too high! G-10 is a bit nasty to cut but it
is the "best". Even a large rotary could probably get away with 3/8
material so the 3/8 thick 12 x 12 should be fine (63407621) at $41.19.
Even the super best G-11/FR5 is $60.92 (63408512).
At 11:46 AM 5/8/2002 -0700, you wrote:
> I'm currently trying to gather information and resources to build an SRSG.
>I have noticed that most rotory disks are made of Phenolic LE or G10.
>The research I have done so far shows that both of those materials
>are pretty pricey. I have found them to run about 105.00 dollars per
> Do any of you have a more economical solution or resource?
>I will not risk safety so if I need to pay those prices I will. I'm just
>checking to see if there is an alternative.