[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: tubing - VTTC

To: tesla-at-pupman-dot-com
Subject: Re: tubing - VTTC
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Fri, 28 Jun 2002 08:26:34 -0600
Resent-Date: Fri, 28 Jun 2002 08:27:25 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <fWrWd.A.KXB._IHH9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Dwight.Crider-at-regulusgroup-dot-com>


Years ago I fabricated a tube with sheets of ?acrylic? or ?styrene? by
heating in hot water and forming over cardboard with several layers, each
laping the previous joint and sealed with acetone. Do not use fingernail
polish remover because it contains oils that cause problems. This might be
cost effective.

Dwight Crider

Prev by Date: Re: Another sad Aussie coil story, primary capacitance
Next by Date: RE: FW: Re: Tesla Coil Efficiency Test
Prev by thread: Re: tubing - VTTC
Next by thread: Re: New secondary, John Freau efficiency theory...etc.
Index(es):
- Date
- Thread