Re: 1/20 HP for Rotor SRSG

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <FutureT-at-aol-dot-com>

In a message dated 7/23/02 2:10:45 PM Eastern Daylight Time, tesla-at-pupman-dot-com
writes:

Dan,

Not all 1/20 HP motors are created equal.  I use a 1/20 HP 3600 rpm
motor on my SRSG which uses a 3/8" x 6 1/2" G-10 rotor, with two 3/8"
copper spinning electrodes in the rotor.  This is the rotary that has
the extended hub. This rotary (and others) can be seen at my website at:

  http://hometown.aol-dot-com/futuret/page3.html

John



>
> I'm purchasing a 1/20HP rotor.  Do you think thats powerful enough to power
> a 6 inch or 7 inch 1/4" thick phenolic using (4) electrodes holders
> comprised of 1/4-20 hex bolts  as various people have done or do i need a
> more powerful motor.
>
> Thanks again.
>
> Dan
>
>
>
>