Re: Toroid Construction - Need something good . . .

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "rheidlebaugh by way of Terry Fritz <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>

A dremmel cut off disk is the easiest way I found.  Angle cutting aviation
tin snips will work, but not as well.
   Robert  H

> From: "Tesla list" <tesla-at-pupman-dot-com>
> Date: Fri, 19 Jul 2002 16:35:32 -0600
> To: tesla-at-pupman-dot-com
> Subject: Re: Toroid Construction - Need something good . . .
> Resent-From: tesla-at-pupman-dot-com
> Resent-Date: Fri, 19 Jul 2002 16:42:03 -0600
> 
> Original poster: "Ed Phillips by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <evp-at-pacbell-dot-net>
> 
> Tesla list wrote:
>> 
>> Original poster: "rheidlebaugh by way of Terry Fritz
> <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>
>> 
>> Randy; I have had good luck using 2 stainless steel mixing bowls. Just cut
>> and sand off the outside lip and soft solder the two together with pure tin
>> solder for stainless steel. with care you will be hard put to see the seam.
>> Robert  H
> 
> How did you cut those rims off neatly and without ripping your fingers
> to shreds
> ?
> 
> Ed
> 
> 
> 
>