[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Attaching Tungsten Electrodes to Rotor etc...

To: tesla-at-pupman-dot-com
Subject: Re: Attaching Tungsten Electrodes to Rotor etc...
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Fri, 19 Jul 2002 16:30:04 -0600
Resent-Date: Fri, 19 Jul 2002 16:36:03 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <8_PMfB.A.R5H.QRJO9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "tesla by way of Terry Fritz <twftesla-at-qwest-dot-net>" <tesla-at-paradise-dot-net.nz>

Hi, Dan Ted in NZ here
I used modified 10mm bolts as holders.
i) Drill hole 5mmdia full length to hold tungsten rod
ii) Drill hole across diameter of hex head (right thru)
iii) Drill and tap for 3mm grub screws

The 10mm bolts are used to hold the ring on the disk
Best
ted L

Prev by Date: RE: GE HV Research
Next by Date: Re: GE HV Research
Prev by thread: Attaching Tungsten Electrodes to Rotor etc...
Next by thread: Re: Attaching Tungsten Electrodes to Rotor etc...
Index(es):
- Date
- Thread