[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Lexan (polycarbonate)

To: tesla-at-pupman-dot-com
Subject: Re: Lexan (polycarbonate)
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 02 Jul 2002 13:03:22 -0600
Resent-Date: Tue, 2 Jul 2002 13:05:23 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <G7Z3PC.A.1HD.dlfI9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Kidd6488-at-aol-dot-com>

In a message dated 7/2/02 9:19:10 AM Eastern Daylight Time, tesla-at-pupman-dot-com
writes:


>
> As for a rotary disc, forget it. Check the heat deflection temperature and
> you'll find it low enough to cause concern. I recommend only linen phenolic
> laminate, or any of the fiberglass reinforced G-series epoxy laminates.



Hello, 

Where can one find G-10 and such?
---------------------------------------
Jonathon Reinhart
hot-streamer-dot-com/jonathon

Prev by Date: Re: 811 tube coil
Next by Date: Re: Sheppard-Talyor circuit up on my website/ low Z construction technique
Prev by thread: Re: Lexan (polycarbonate)
Next by thread: Re: Lexan (polycarbonate)
Index(es):
- Date
- Thread