[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Lexan (polycarbonate)

To: tesla-at-pupman-dot-com
Subject: Re: Lexan (polycarbonate)
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 02 Jul 2002 07:12:47 -0600
Resent-Date: Tue, 2 Jul 2002 07:13:55 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <2QV2pC.A.pqF.JcaI9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Mr Gregory Peters by way of Terry Fritz <twftesla-at-qwest-dot-net>" <s371034-at-student.uq.edu.au>

Dr Res:

I know this. My question was regarding its use as a coil end cap, not as
an RSG rotor. My 1HP sync gap uses a g10 rotor. I was just considering
using it for a small table top coil one day.

Cheers,

Greg Peters
Department of Earth Sciences,
University of Queensland, Australia
Phone: 0402 841 677
http://www.geocities-dot-com/gregjpeters

Prev by Date: Re: FW: Re: Tesla Coil Efficiency Test
Next by Date: Re: Sheppard-Talyor circuit up on my website/ low Z construction technique
Prev by thread: Re: Lexan (polycarbonate)
Next by thread: Re: Lexan (polycarbonate)
Index(es):
- Date
- Thread