[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: PVC secondaries

To: tesla-at-pupman-dot-com
Subject: Re: PVC secondaries
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Mon, 01 Jul 2002 07:56:58 -0600
Resent-Date: Mon, 1 Jul 2002 08:00:55 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <o5HV4B.A.pyF.ACGI9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Mr Gregory Peters by way of Terry Fritz <twftesla-at-qwest-dot-net>" <s371034-at-student.uq.edu.au>

PVC can be dried easily by putting a few lightbulbs inside the form. 
Even easier is to cap one end and then place a small fan heater in the 
other. This held my 12" coilform at nearly melting point.

Cheers,

Greg Peters
Department of Earth Sciences,
University of Queensland, Australia
Phone: 0402 841 677
http://www.geocities-dot-com/gregjpeters

Prev by Date: Re: 811 tube coil
Next by Date: Re: 811 tube coil
Prev by thread: Re: 811 tube coil
Next by thread: Re: PVC secondaries
Index(es):
- Date
- Thread