Re: Suspended Primary for Mini-TC?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jolyon Vater Cox by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jolyon-at-vatercox.freeserve.co.uk>

Matt,
Logically, you are correct. I have looked at the secondary dimensions on my
spreadsheet and in fact the Minimum diameter was 2.894630527" and the Max
dia was 2.938630527" (pardoning the unnecessary digits which are the result
of calculating to sixteens of an inch on a spreadsheet!) so in reality the
minimum diameter is not bigger than the maximum,contrary to common sense.

The Wire dia was of course 0.022
equal to (Max dia/" - Min dia/")/2.

Jolyon.


----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, November 30, 2002 2:06 AM
Subject: Re: Suspended Primary for Mini-TC?


 > Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<Mddeming-at-aol-dot-com>
 >
 > In a message dated 11/29/02 3:54:10 PM Eastern Standard Time,
 > tesla-at-pupman-dot-com writes:
 >
 >
 >
 > >My secondary was a 10.375"high x 2.89" dia winding of 880t of 32SWG wire
 > >(the diameter of the former upon which it was wound was 2.94").
 >
 >
 > How do you wind a coil that is smaller in diameter than the form it is
 > wound on?
 >
 > Matt D.
 >
 >
 >