[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: How do you cut Tungsten Rods????

To: tesla-at-pupman-dot-com
Subject: Re: How do you cut Tungsten Rods????
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 13 Aug 2002 20:29:25 -0600
Resent-Date: Tue, 13 Aug 2002 20:29:47 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <EzpdRB.A.TsH.FCcW9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Parpp807-at-aol-dot-com>

Dan,
I use a Dremel tool or a bench grinder to circumscribe the rod.
Clamp the rod in a vise to get a clean break.

Cheers,
Ralph Zekelman

Prev by Date: Re: neon tube indicator
Next by Date: Re: neon tube indicator
Prev by thread: Re: How do you cut Tungsten Rods????
Next by thread: Re: How do you cut Tungsten Rods????
Index(es):
- Date
- Thread