Re: Ignition Transformer

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Lux by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jimlux-at-earthlink-dot-net>

No idea... Perhaps it fits a Wayne burner... Side and end hinge might
indicate which side the screws are on.  The one OBIT I've seen, that I
recall what it looks like, had tabs sticking out of two opposite ends, with
a screw hole on one end.  It installed with the "non-hole" tab into a slot,
then folded down and you put one screw in.

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Wednesday, March 27, 2002 7:39 PM
Subject: Re: Ignition Transformer


> Original poster: "Ed Phillips by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<evp-at-pacbell-dot-net>
>
> Tesla list wrote:
> >
> > Original poster: "Jim Lux by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <jimlux-at-earthlink-dot-net>
> >
> > Grainger part #s 2E507, 2E508, 2E509 (OBIT for Wayne End Hinge, Wayne
Side
> > Hinge, Beckett, respectively), list $38.66 each (France model # 5LAY-03,
> > -30, -04)
> > Grainger part #s 2E538 OBIT for General Use $42.38  (France model #LA4V)
>
> I looked at the same listing.  What, prey tell, is a "Wayne End Hinge"
> (or side hinge)????????
>
> Ed
>
>
>