[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: how to hold down primary



Original poster: "R Heidlebaugh by way of Terry Fritz <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>

on 10/03/01 8:16 AM, Tesla list at tesla-at-pupman-dot-com wrote:

> Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <Hollmike-at-aol-dot-com>
> 
> Shaun, 
> You can do a number of things to hold it down.  You could use wire ties if
> you drill small holes below the slots to feed them through.  Good strong
> fishing line would probably work as well.  You could probably epoxy them into
> place as well if you are happy with it and don't plan to make any changes.
> Mike 
> 
> 
> 
>> 
>> I needed to ask you how to hold down the turns of copper tubing.  I've made
>> 8 supports with slots cut and drilled into them, then I lay down the tubing
>> into the slots and volla, one primary.  But it doesn't lay flat enough and
>> it wouldn't take much to jar it out.
> 
> 
> 


I use 5-min epoxi
      Robert H