Re: how to hold down primary

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Steve White by way of Terry Fritz <twftesla-at-qwest-dot-net>" <slwhite-at-zeus.ia-dot-net>

I drilled a hole under each slot and then secured each turn at each slot
position with a nylon tie wrap run through the hole and over the primary
tubing.

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Tuesday, October 02, 2001 12:34 PM
Subject: how to hold down primary


> Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<biomed-at-miseri.winnipeg.mb.ca>
>
>
> Hello group,
>
> I needed to ask you how to hold down the turns of copper tubing.  I've
made
> 8 supports with slots cut and drilled into them, then I lay down the
tubing
> into the slots and volla, one primary.  But it doesn't lay flat enough and
> it wouldn't take much to jar it out.
>
> Any input would be appreciated,
> Thanks,
>
> Shaun Epp
>
>
>
>