[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

110KV BIL?

To: tesla-at-pupman-dot-com
Subject: 110KV BIL?
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 15 May 2001 20:58:13 -0600
Resent-Date: Tue, 15 May 2001 20:58:47 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <mSMqTD.A.b6E.IzeA7-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Ray Haynes by way of Terry Fritz <twftesla-at-uswest-dot-net>" <ray.haynes-at-home-dot-com>

On a potential transformer what does the BIL rating mean? My only guess it's
the breakdown voltage from the high voltage winding to either the case or
low voltage winding. Is that correct?

If that is true then if I had 2 potential transformers (120 to 14.4KV) each
with 110KV BIL then I could connect the HV sides in series (for 28.8KV) and
not worry about breakdown from either high voltage winding to anywhere (case
or low voltage winding) caused by the transformers themselves (excluding any
tesla related arcs)?


Ray

Prev by Date: Re: [TSSP] Measured vs. Operating coil coupling?
Next by Date: Mica Cap Question
Prev by thread: Re: Ammonia spark gap ?
Next by thread: Re: 110KV BIL?
Index(es):
- Date
- Thread