Re: "best" former material?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Luc by way of Terry Fritz <twftesla-at-uswest-dot-net>" <ludev-at-videotron.ca>

Hi Greg

Is Goop a kind of acrylic or the glue use to make tape sticky ?

Luc Benard

P.S. I have 2 X ( 4.5" X 30" ) polypropylene pipe in my shop but I wait for
a solution
before I use it . I don't know if it could work but I plan to wind the coil
with an hair
dryer blowing hot air on the windings, may be the coil will contract itself
went it cool
down ???

Tesla list wrote:

> Original poster: "G by way of Terry Fritz <twftesla-at-uswest-dot-net>"
<nieporgo-at-email.uc.edu>
>
> >Original poster: "Chris Snyder by way of Terry Fritz
> ><twftesla-at-uswest-dot-net>" <csnyder-at-ga.prestige-dot-net>
> >
> >Anybody thinking of using polypropylene,
> >     Just a heads up to anyone who's going to use polypropylene...  I'm just
> >about finished winding a secondary on polypropylene... The one bad thing I
> >can say about it is that it is nearly impossible to bond to.  Tried all
> >kinds of epoxies, they just fall right off of it. Most epoxies even say not
> >for use on polypropylene. Luckly, polyeurethane holds well enough to keep
> >the windings on, but a few flexes of the form and they'll fall right off. :P
> >
> >Chris Snyder
> Go to any hardware store and buy Marine Goop in the glue section.
> This stuff works miracles and I used it to bond all my ldpe
> insulating parts to wood.
> Tough glue to beat for all jobs.
> Greg
> --
>
> ____________
> ICQ 95403614