Re:Re: spun toroids

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Tesla729-at-cs-dot-com>

In a message dated 5/30/01 9:47:40 PM Central Daylight Time, tesla-at-pupman-dot-com 
writes: 


>
> Try here.  I did a bulk toroid buy a while back. 
> The quality is EXCELLENT. 
> Be prepared to spend $$$ for short runs though.  The price gets very 
> reasonable for quantities. 
> We did 50 pieces for the bulk buy. 
>
> Make sure you get the 6061 aluminum, the 1100 is softer and tends to 
> dent more easily. 
> Also ask for extra packaging material, especially overseas, as some had 
> to be replaced due to 
> dents in shipping. 
>
>
> Mark R. Pratt, V.P. 
> > > Phone 413/445-5632 
> > > Fax 413/499-0614 
> > > EMAIL owlspin-at-vgernet-dot-net 
> > > WEB www.owlandergren-dot-com 
> > > Thank You 
> > > 
> > 
> > > > OWLandergren wrote: 
> > > > > 
> > > > > Jim: 
> > > > > We have over 75 different toroid sizes. Since we are a job shop, we 
> > > > > manufacture parts to order, therefore the toroids are not in 
> inventory. 
> > > > > the piece price is based on the run 
> > > > > quantity. With the set up cost for each operation amortized into the 
> > > > > quantity being run. 
> > > > > Please send me your business address or your fax number and I'll 
> send you 
> > > > > a list of  the 
> > > > > available toroid sizes. 
> > > > > Thank you very much for your interest in our company. 
> > > > > Mark r. Pratt, V.P. 
> > > > > 
>
>



Hi all, 

I was just wondering if there may be enough piggie coilers 
out there that would be interested in a bulk buy of larger 
toroids like say 8" X 32". The 6"X 24" ones looked great 
form the pics, but these just wouldn't be quite big enough 
for my 10 kVA pig system. I know the cost would be prohi- 
bitive for single orders, but may become somewhat more 
affordable if enough people were interested. If we could get 
them for < $250 each, that would be a definite plus :-) 

Sparkin' in Memphis, 
David Rieben