Re: Toroid

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Luc by way of Terry Fritz <twftesla-at-qwest-dot-net>" <ludev-at-videotron.ca>

Hi Brian 

Could you post a photo of it somewhere ( the fan shroud alone or
mounted on a coil )

Cheers,

Luc Benard

Tesla list wrote:
> 
> Original poster: "brian by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<ka1bbg1-at-mcttelecom-dot-com>
> 
> Hi, i use a fan schroud for a second large toroid. the only problem i have
> is it is taped together with electrical tape and once in a while ill get a
> burn spot and then it acts like breakout point. the indentation on one
> side(clearance space for the motor) doesnt seem to affect operation. I have
> dryer duct but havent made a toroid with it yet. but i suspect it wont make
> much difference. i have looked at a lotta tesla sites and see toroids made
> of dryer duct all the time. sure a nice alum spun toroid is probably best
> but nothing beats a toroid made for 10 bucks that works! cul brian
> 
> ----- Original Message -----
> From: "Tesla list" <tesla-at-pupman-dot-com>
> To: <tesla-at-pupman-dot-com>
> Sent: Tuesday, June 05, 2001 10:53 PM
> Subject: Toroid
> 
> > Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <Gbjsjg-at-aol-dot-com>
> >
> > How does the wire toroid compair to the aluminum drain pipe toroid?
> >                                                                         -M
> ax
> > Joseph
> >
> >
> >
> >