[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Undesired "effect" with saltwater caps



Original poster: "rheidlebaugh by way of Terry Fritz <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>

Capacitors used in a TC pass high current,100 amps or so. Aluminum foil is
thin and wont take high current unless well connected with a strap or some
other good connection. Some people use a bucket of salt water to make the
outside connection. This is quite bulky and messy, but works if the outside
is insulated from the ground.
  Robert  H

> From: "Tesla list" <tesla-at-pupman-dot-com>
> Date: Sun, 23 Dec 2001 21:38:15 -0700
> To: tesla-at-pupman-dot-com
> Subject: Undesired "effect" with saltwater caps
> Resent-From: tesla-at-pupman-dot-com
> Resent-Date: Sun, 23 Dec 2001 23:50:10 -0700
> 
> Original poster: "Chris by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> <chris-at-atomic-pc-dot-com>
> 
> Hi all,
> 
> I realize that many experienced coil builders frown upon salt water
> caps, but right now I'm trying to make the most of available materials.
> So I have a cardboard box set up with 8 Snapple bottles in parallel.
> Experimenting with different numbers of bottles does not significantly
> affect the problem I'm about to mention.
> 
> What's happening is, now that I've switched to a series of copper tube
> sections as my spark gap (8 tube segments in series, ca. 1 mm apart),
> I'm getting big, loud (!) sparks inside the Snapple box which appear to
> be going from one bottle cap to the neighboring outside plate of the
> next bottle (this is several inches' distance).  Close examination of
> the bottles (after disconnecting, of course :-0 ) reveals myriad
> pinhole-sized burns through the aluminum foil on the outsides of the
> bottles, although the glass is intact and they do not appear to leak.
> The secondary will throw about 6 inches of spark if I experiment with #
> of primary turns.
> 
> I'm using a 10 KV, 23 mA furnace transformer.  I've tried 3 different
> primary coil setups, including one of insulated Romex 12 ga. stranded
> wire, coupled very closely to the secondary. Maybe the coupling here is
> too close?  But the problem happens also with the copper refrigeration
> tubing that's spaced much farther from the secondary.
> 
> What could be happening here?  Another note, some of the wires I'm using
> in the primary circuit are way too thin (16 ga. wire, with alligator
> clips to connect things).  Could this be introducing too much reactance
> into the primary circuit?  (please forgive my ignorance of these
> things).
> 
> Thanks,
> Chris
> 
> 
> 
> 
> 
>