Fw: More Secondary questions

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Shaun Epp by way of Terry Fritz <twftesla-at-qwest-dot-net>" <scepp-at-mts-dot-net>

Hello Group:

Question:

  1. is it OK to use super glue (cryoacrilate) to hold the secondary
windings  in place while I wind or would it comprimise insulation?

 2.  I have a spark gap.... 3   3/8" x 2 1/2"  sections of tungsten that
 form  2 gaps.   They are mounted on collars and supports.   I was going to
energize it with first an OBIT, then later a 15kv at 60ma NST.  Does any
have any feedback about me using only 2 gaps?

  3.  Since all the talk about triggered gaps, I was thinking about
 energizing  the middle tunsten rod with a trigger cct.   Question: would
this series  arrangment work?

  4.  This is really cool, I was at a local surplus store  "Princess Auto" I
think they're Canadian only ...  and I saw /tested some small ( 1.5 to 2.0 "
dia) squirrel cage fans.  The motor was the same as a RC car motor and
required 10volts DC at ~1 amp.  They pushed lots of air through a ~1/2 "
tube/hole, They seem purfect to quench a spark gap.  I believe the spec was
44 CFM.  What do ya think?