Re: Bleeder resisters

["Steve" <Steve-at-xxxxxxxxxxxxxxxxxxxxxxxxxxxxx> (by way of Terry Fritz <twftesla-at-xxxxxxxxxx>)]

There probably is a way of working it out, but I've always used 10M across
each cap, without problems with caps up 1mfd.  There is little point in
going lower in value, and you are more likely to have problems with lower
values anyway. I would say this though, make sure you use appropriately
rated metal film resistors.
----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, November 09, 2000 2:44 PM
Subject: Bleeder resisters


> Original poster: "Neil Chambers" <Neil_Chambers-at-paragon-it-dot-com>
>
> Hi
>
> How do I decide what value resisters to use as bleeder resisters for my
> proposed MMC?
>
> Thanks
>
>
>
> Neil
>
>
>
>