[Prev][Next][Index][Thread]
Re: Seconday form length question
Howdy,
I left an extra 8 inches at the bottom of my secondary. It slides into a
hole in the top of the table in the middle of the primary. I can place
spacers under the secondary to raise it. Works for me.
George Stein
----- Original Message -----
From: Tesla List <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, March 27, 2000 1:21 PM
Subject: Seconday form length question
> Original Poster: "Bob Berg" <berg_bob-at-hotmail-dot-com>
>
> Would it hurt performance if I leave an extra 12 - 16" of PVC at the end
> (bottom) of my seconday. (Unwound) I want to have the seconday pass
through
> the top of the support table and and secure it at the base. Of course I
> would only have the winding from where I needed from the primary up 22-24
> inches (4.5" seconday). This will also allow me to adjust coupling by
> allowing me to move it up or down.
> --- Has anyone come up with a way to adjust coupling while the coil is
> running? some kind of motorized system that would allow the operater to
> raise or lower the seconday while the coil is running? Sounds
interesting.
>
> Thanks
> Bob
>
>
>
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail-dot-com
>
>