More Question about ballasting and VA...

• To: tesla-at-pupman-dot-com
• Subject: More Question about ballasting and VA...
• From: "Bunnykiller" <bigfoo39-at-idt-dot-net> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)
• Date: Sun, 05 Mar 2000 21:19:57 -0700
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme

Hi All.....


I got my variac installed today into my system and the strangest thing
occured...   I am using 4 EI cores wound with approximately 180 turns of
THHN #10 solid copper ...  when i tested the units on 240V  the 2
smaller units drew  4 and 5 amps respectively   the 2 larger units drew
12 and 15 amps ...  the wiring goes as follows  


240 into a main switch, main switch to the variac inputs, variac outputs
to the inductors and pig ( one leg to the inductors the other leg to the
pig) ...


once i wired everything up i tested the system on a Jacobs ladder ( pig)
the larger inductors pulled the same current ( as the test 12 & 15) but
the smaller units allowed massive amounts of current to flow.... 40 - 60
amps surges... blew the fuse on the variac 3 times during tests..

WHY   am I seeing this large surging with the 2 smaller inductors ???

before i installed the variac  i had no problem with this surging or hi
current flow...


Scot D

• Prev: !!~!Re: Question about ballasting and VA
• Next: Variac controlled inductive ballast - WARNING
• Index(es):
  • Main
  • Thread