[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Oklahoma Biggg coil update



How are you able to measure the mh of the coil. Do you have a meter that
does this or do you calculate this.. thanks...
-----Original Message-----
From: Tesla list <tesla-at-pupman-dot-com>
To: tesla-at-pupman-dot-com <tesla-at-pupman-dot-com>
Date: Saturday, July 15, 2000 6:43 PM
Subject: Oklahoma Biggg coil update


>Original poster: "Kevin R Eldredge" <kreld-at-juno-dot-com>
>
>
>
>
>  All
>
>  Progress continues on the Biggg coil.  The secondary coil is
>finished.  It is an open form
>2' dia x 10' long wound with 6000' of #14 P.V.C. wire.   The center is
>a 10' #40 P.V.C. pipe with 7 plywood disks equally spaced.  The disks
>are notched to accept 1" X 2" wood spars and 8 drain type P.V.C. 4"
>pipes, one on each spar.   Inductance 96 mH, 15 ohm d.c. resistance.
>
>   Last weekend the 20 foot hoist tower is in place to lift the 200 LB
>secondary onto the roll out platform.  It was tested lifting a 250 LB
>pig (not the animal kind) using a compound pulley hoist with success.
>
> All that's left is the track for the roll cart & the primary coil
>assembly.   First firing is getting close, possible middle/late Summer
>if all goes well.
>
>Safe coiling
>>
>>Kevin E.
>
>________________________________________________________________
>YOU'RE PAYING TOO MUCH FOR THE INTERNET!
>Juno now offers FREE Internet Access!
>Try it today - there's no risk!  For your FREE software, visit:
>http://dl.www.juno-dot-com/get/tagj.
>
>
>