[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Is this a good circuit for a tesla coil. Any suggestions



Jeremiah-
It's easier, faster and cheaper to just put a dimmer and 5uF cap in series
with an ignition coil, then run it off of mains. You'll get the same, if not
better, voltage with adjustable frequency/duty cycle.

Schematic:(sort of)

HOT ~ o---[[[/]]]---{((()))}----UUUU----o ~ NEUTRAL
                (dimmer)   (cap)     (ignition coil)

The highest setting on the dimmer gives shorter arcs, but more current.
Lowest setting gives you looooong arcs but really low current (still hurts
: ).
These can be used in place of an OBIT in small coils, and they'll probably
last longer as the oil in the ignition coil doesn't become conductive at
really high frequencies like tar, and any carbon tracks will melt away if
you shake up the oil a little.
Hope that helped...

    -Michael





----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Tuesday, August 22, 2000 6:49 PM
Subject: Is this a good circuit for a tesla coil. Any suggestions


> Original poster: "Jeremiah" <jmeizis-at-metallicafan-dot-com>
>
> this is a circuit from a book called George McComb's Gadgeteer's Goldmine.
> It uses a 555 IC and ignition coil to drive a traditional tesla coil if
you
> will.  Any Improvements.  Anybody tried this circuit.  It was adapted from
> Walt Noon's 40000 volt induction coil plans.  The parts marked on the
> schematic and the ones on the part list are different does andbody know
> which ones are better.  See attachments.  Thanks.
> Jeremiah
>
> http://63.225.104.218/site/TCList/tesla.jpg
> http://63.225.104.218/site/TCList/tesla201.JPG
>
>
>
>
>
>
>