[Prev][Next][Index][Thread]

BRAG schematic



Binary Resonant Arc Gap schematic;
   In posting this to another discussion
list I noticed that when I drew the schematic 
on word pad and pasted into excite compose
mail it came out garbled because of different
font sizes? I am therefore attempting to write this 
again directly from the mailbox this time, forgive if it is garbled.
                   0
                   !
            -----------------
            !               !
            !               !
           cap             coil
            !               !
            !------ X ------!             
            !               !
           coil            cap
            !               !
            !---------------!
                    !
                    0
  Cap and coils are identically designated
to resonate at the input frequency. X is the 
placement of the arc gap. 0's are AC input.
  
  Arc across gap represents special tank circuit occurring
as two caps in series being in parallel with two coils in 
series. As such its respective inductances and capacitances
are doubled in this circumstance. However this doubling
only serves to double the internal resistance of that 
experienced in a SINGLE parallel resonant. It does not
change the frequency at which the circuit resonates.
(In the experiments I made L and C were given values
to resonate at 120 v , 60hz,with identical values on 
each side of course.) This tank circuit has the special
distinction of allowing the midpoint path where the arc
occurs to be shared by both the inductive AND
capacitive branches of current flow; however these
expressed currents are themselves opposite or 180 phased.
BECAUSE of the fact that this current path itself
is shared in OPPOSITE directions by both, instead of 
a cancellation effect a doubled negative occurs in which
these currents that are normally 180 out of phase are 
then in unity across this pathway,thus the measured current
on closed switch position or dead short is twice that
of the sides alone.	
       It should then be obvious that the open switch
position (which in this air gap analogy represents the
quenched arc) then represents an entirely new condition:
that of two series resonant phases at 180 phasing. At 
the moment one phase experiences a positive resonant
rise of voltage the other produces a negative. Thus the 
measured voltage BETWEEN the midpoints where the 
arc occurs is then TWICE that of either side alone.
Indeed it is this dual opposite rise of voltage on each
side that enables the arc to take place in the first place.
 In the 56 H binary system intially constructed this voltage
rise was about 30/1 enabling a high frequency effect
form the arc gap to accur at wall voltage conditions
alone without the use of a step up transformer!
Further modifications produced a typical tesla arcing
across a water capacity that was impressive in that this
1/3 inch discharge of miniature lightening is produced
at an energy discharge estimated at 10 watts input!      
      The condition during arcing changes  the condition of  
minimum or zero reactance to that of one of maximum 
impedance  which in the case of large inductors where 
the q's of the coils have caused the ignition at the spark
gap, the instant withdrawal of this resonant rise of voltage
to a new condition of practically no voltage at the arc gap,
contradicted by the new condition of resonant rise of 
amperage instead of  voltage rise still nevertheless very
efficiently quenches the arc which is usually violet or blue
disharges. Again whether this same kind of arc gap
used in conjunction with two tesla primaries could be 
made is open to experimentation. Sometimes more 
important agendas assert themselves.
       IT SHOULD BE SEEN THAT THIS TANK CIRCUIT
CONSISTS OF TWO SERIES L AND C  BRANCHES 
IN PARALLEL WITH THE DISTINCTION THAT IT
HAS BEEN TWISTED INTO A FIGURE 8, MAKING
A NEW PATHWAY SHARED BY BOTH SIDES
FROM OPPOSITE DIRECTIONS WHEREBY
AN ARC GAP IS PLACED AT THIS MIDPOINT.
THIS REPRESENTS A FLUCTUATION
BEWEEN SERIES  AND PARALLEL RESONANCES
RATHER THAN AN OSCILLATION IN AND OUT
OF PARALLEL RESONANCE AS OCCURS IN A
TYPICAL TESLA PRIMARY. AN OBJECTION
MAY BE MADE THAT THE RESONANT RECHARGING
METHOD IN TESLA PRIMARY ARC GAPS INCORPORATES
BOTH A SERIES AND PARALLEL CONFIGURATION,
BUT AS THE POSITION OF THE ARC GAP SHOWS
IN THE SCHEMATIC, THIS METHOD IS ENTIRELY
DIFFERENT THE FORMER. HDN




_______________________________________________________
Get your free, private email at http://mail.excite-dot-com/