Hello fellow coilers. As some of you may or may not know im a student
and my coil was built for an electronics project. Ive been toying with
the idea of small poly caps on cards all held in one tank and bussed
together. Other than a major pain to cut and assemble is there any other
factors im not seeing? I feel blowing caps is a part of coiling so the
modular cap would allow you to remove the blown section or sections and
replace only them and not sending a partially good cap to the trash. Any
thoughts comments criticisms welcome.
Philip Mac Duffie
BTW the MMC cap looks like a good idea and I may try it but where can I
order the caps from?