Re: secondary winding

• To: tesla-at-pupman-dot-com
• Subject: Re: secondary winding
• From: "Harvey Norris" <tesla4-at-excite-dot-com> (by way of Terry Fritz <twf-at-verinet-dot-com>)
• Date: Sun, 07 Mar 1999 19:33:59 -0700
• Approved: twf-at-verinet-dot-com

On Sun, 07 Mar 1999 02:07:12 -0700, Tesla List wrote:

> Original Poster: "Ian S" <ian115-at-hotmail-dot-com> 
> 
> Hi all - 
>  
> I was woundering if any of you had any tricks for winding secandaries?
> 
> 
> Thanks in advance!
> 
> Ian
>Take 4 garage door rollers and mount them on a picnic table so the tube can
roll on them placed on the edges. One person rolls the tube while the other
keeps tension on the spool of wire. This is still a lot of work. If I were
to do this again I would probably pour a thin layer of melted parafin over
the finished coil to keep the windings from seperating. It is a real pain
trying to get windings back in place if they slip out of position. I used a
20 inch diameter fiber core for the core. HDN 
> 
> 
> 
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail-dot-com
> 





_______________________________________________________
Get your free, private email at http://mail.excite-dot-com/

• Prev: Re: Partial Discharges.....A good reason for cap failure?
• Next: Re: Zinc based spark gap
• Index(es):
  • Main
  • Thread