primary hold down's

• To: "'Tesla List'" <tesla-at-pupman-dot-com>
• Subject: primary hold down's
• From: Tesla List <tesla-at-stic-dot-net>
• Date: Fri, 6 Mar 1998 23:08:27 -0600
• Approved: tesla-at-stic-dot-net

----------
From:  Walt Kulpa [SMTP:gwkulpa-at-earthlink-dot-net]
Sent:  Friday, March 06, 1998 12:27 PM
To:  tesla-at-pupman-dot-com
Subject:  primary hold down's

Hi, I'm working on the form for my 1/4" refigerator tubing primary. 
I'm planning on using 1/4" polycarb for the support fins. I've got the 
calculations made on where to notch the plasitc in order to create a 
nice uniform  30degree slope and 15 degree rise with 1/4" spacing 
between turns, but what I don't have is, what can i do for holding the 
tubing into the notches? I don't want to just let it lay there, do I?  
I'm not so sure that adehesive is a good idea, is it? How is holding the 
tubing into the plastic commonly done?
Thanks, Walt Kulpa

• Prev: High Voltage Test Equipment
• Next: ok design?
• Index(es):
  • Main
  • Thread