[Prev][Next][Index][Thread]
Secondary Frequency(fwd)
----------
From: Mark S Graalman [SMTP:wb8jkr-at-juno-dot-com]
Sent: Wednesday, August 19, 1998 4:33 AM
To: tesla-at-pupman-dot-com
Subject: Re: Secondary Frequency(fwd)
Being a bit lazy ;) the freq of coil B according to
TESLAC 2.06 is 276 Khz, coil A won't calculate
due to the 6-1 aspect ratio which TESLAC doesn't
like. I reality, the frequency shifts all over the place
depending on where the coil is located, etc. So in
short, any answer between 250-350 Khz is close
enough for government work. <G>
Mark Graalman
On Tue, 18 Aug 1998 23:43:03 -0500 Tesla List <tesla-at-pupman-dot-com> writes:
>
>----------
>From: Esondrmn-at-aol-dot-com [SMTP:Esondrmn-at-aol-dot-com]
>Sent: Tuesday, August 18, 1998 1:17 PM
>To: tesla-at-pupman-dot-com
>Subject: Re: Secondary Frequency(fwd)
>
>In a message dated 98-08-18 10:50:39 EDT, you write:
>
><<
> Hi to All,
>
>
> Below are two given coils.
> What is the frequency of each coil? Another coiler and I disagree on
>the
> resonant frequency of these two coils. Can somebody help?
>
> Coil A:
> 21.7" long
> 3" diameter
> Wound with 1230 feet AWG 28
> He says 418kHz (I say 200 kHz)
>
> Coil B
> 10.84" long
> 6" diameter
> Also wound with 1230 feet AWG 28
> He says 275kHz (I say 200 kHz)
>
> Who is right??
>
> Thanks,
> Reinhard
> >>
>
>Reinhard,
>
>Assuming the length given is the actual winding length and no top
>load, I
>calculate 375 khz for the 3" dia. coil and 296 khz for the 6" dia.
>coil.
>
>Ed Sonderman
>
>
>
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno-dot-com
Or call Juno at (800) 654-JUNO [654-5866]