material to coat secondary

• To: "'Tesla List'" <tesla-at-pupman-dot-com>
• Subject: material to coat secondary
• From: Tesla List <tesla-at-stic-dot-net>
• Date: Sun, 19 Apr 1998 11:03:02 -0500
• Approved: tesla-at-stic-dot-net

----------
From:  D.C. Cox [SMTP:DR.RESONANCE-at-next-wave-dot-net]
Sent:  Saturday, April 18, 1998 11:30 PM
To:  Tesla List
Subject:  Re: material to coat secondary

to: Eric

Use Dolph's AC-43 clear air dry varnish -- won't effect your resonant freq.
and is made for this purpose with enameled magnet wire.

DR.RESONANCE-at-next-wave-dot-net


----------
> From: Tesla List <tesla-at-pupman-dot-com>
> To: 'Tesla List' <tesla-at-pupman-dot-com>
> Subject: material to coat secondary
> Date: Saturday, April 18, 1998 6:19 AM
> 
> 
> ----------
> From:  ESchulz531 [SMTP:ESchulz531-at-aol-dot-com]
> Sent:  Friday, April 17, 1998 5:29 PM
> To:  tesla-at-pupman-dot-com
> Subject:  Re: material to coat secondary
> 
> Kevin,
> 	I used this Valspar Dura-Build Clear-Gloss Epoxy Finish on my secondary,
I
> used two coats, it works good but it lowered my resonate frequency a lot.
> 
> later,
> Erik
> 

• Prev: Kapton
• Next: flat vs angled primary
• Index(es):
  • Main
  • Thread