Re: Adhesive for PE

• To: "'Tesla List'" <tesla-at-poodle.pupman-dot-com>
• Subject: Re: Adhesive for PE
• From: Tesla List <tesla-at-stic-dot-net>
• Date: Fri, 19 Sep 1997 08:49:09 -0500
• Approved: tesla-at-stic-dot-net

From: 	Sulaiman Abdullah[SMTP:sulabd-at-hotmail-dot-com]
Sent: 	Friday, September 19, 1997 1:19 AM
To: 	tesla-at-pupman-dot-com
Subject: 	Re: Adhesive for PE


>
>From: 	Gary Lau[SMTP:lau-at-hdecad.ENET.dec-dot-com]
>Sent: 	Thursday, September 18, 1997 7:22 AM
>To: 	tesla-at-pupman-dot-com
>Subject: 	Re: Adhesive for PE
>
>Another option is a hot-melt glue gun.  Simply laying down a bead of 
the
>stuff will just peel off, but if you rub the tip of the gun into the PE
>to melt it a bit, it will mix with the glue and form a reasonable bond. 
>If you're trying to bond thin sheets, it will warp the stuff, again, 
not
>sure of the application.
>
>Gary Lau
>Waltham, MA
>
Hi, looks great if it works, I'll try a test.
The application is a flat-plate primary capacitor, I've 'blown' my first 
two test capacitors which were rolled-up types - due to short-cuts, 
laziness and impatience. This time I'm going to try 3mm PE sheets and 
oil.  bye ... Sulaiman

______________________________________________________
Get Your Private, Free Email at http://www.hotmail-dot-com

• Prev: Cuk SMPS Course
• Next: Re: Magnetic quenching
• Index(es):
  • Main
  • Thread