Re: Best Secondary Surface coating

• To: "'Tesla List'" <tesla-at-poodle.pupman-dot-com>
• Subject: Re: Best Secondary Surface coating
• From: Tesla List <tesla-at-stic-dot-net>
• Date: Tue, 18 Nov 1997 22:58:18 -0600
• Approved: tesla-at-stic-dot-net

From: 	Mad Coiler[SMTP:tesla_coiler-at-hotmail-dot-com]
Sent: 	Tuesday, November 18, 1997 5:01 PM
To: 	tesla-at-pupman-dot-com
Subject: 	Re: Best Secondary Surface coating

List,

I am in the process of putting together a new coil and was planning on 
using polyurethane to coat the secondary. Is this a good coating 
material or not? I was planning on coating a portion of the sec form and 
then winding the wire over the wet coat of poly. Then I could coat over 
the top. Another main factor in this is cost (like ~$0). I already have 
lots of polyurethane from doing woodworking. Comments on polyurethane as 
a secondary coating?

Tristan Stewart

• Prev: Re: kVA Effects
• Next: Re: Westcode Devices
• Index(es):
  • Main
  • Thread